Singnet Modem Setting


Status
Not open for further replies.
Apr 20, 2006
1,087
0
0
#1
Hello,

Since Singnet has refused to publish their modem settings, perhaps someone can help me out here...

I have always used the following setting with no problems until this week:

VPI=0
VCI=100
Virtual Circuit=Enabled

WAN Setting = PPPoE/PPPoA
Connection Type=PPPoA VC-Mux
MRU=1500
Default Route=Enabled
NAT=Enabled

ATM Service Category=UBR
PCR and SCR left blank

I read in some forum some time ago that these work. However, I have discovered through trial and error that if I set the Connection Type to 'PPPoE LLC', it will work too.

I don't know why Singnet has refused to publish their modem settings. When I write in to them, they will apologise for not doing so, but they would still not tell me the setting (I really don't know why).

Can someone tell me what is the correct setting please?

Thanks.
 

dEthANGeL

Senior Member
Jun 20, 2004
1,652
0
36
Siglap
#2
PPPoA is overall a better connection as compared to PPPoE
 

Status
Not open for further replies.
Top Bottom