Putting it on ...


Status
Not open for further replies.

ndroo

Moderator
Staff member
Nov 22, 2003
8,243
3
0
47
www.fuzzyeyeballs.com
www.fuzzyeyeballs.com
#1
How do you guys install the LCD protectors for your cam? I tried (and already down to the last piece :() but seem that i find lots of bubbles in it. Tried 'pushing' them away using the supplied piece of 'card' ... helps a bit but then the LCD protector end up having some lines (scratches). Given up for now, until someone can guide me the correct (or easier way). Thanks
 

ST1100

Senior Member
Jun 18, 2003
1,785
0
0
Singapore, Bedok
#2
Put a drop of alcohol or lens cleaner on the lcd before putting the protector on. Same technique as PDA screens.
 

ndroo

Moderator
Staff member
Nov 22, 2003
8,243
3
0
47
www.fuzzyeyeballs.com
www.fuzzyeyeballs.com
#3
ST1100 said:
Put a drop of alcohol or lens cleaner on the lcd before putting the protector on. Same technique as PDA screens.
aahhh ... will that result in the alcohol/lens clearner flowin into the LCD? so this method will result in no bubbles etc? as for alcohol, vodka can ka? *lol* just joking ... will try that tomorrow with lens cleaner ...
 

ST1100

Senior Member
Jun 18, 2003
1,785
0
0
Singapore, Bedok
#4
If you're nervous about it start with a very small drop, or drop it on the protector instead of the LCD. Have a dry cloth or tissue nearby to quickly wipe up the excess.
 

Status
Not open for further replies.
Top Bottom