Flash contact masking


Status
Not open for further replies.

lastboltnut

Senior Member
Mar 23, 2006
4,528
0
0
Where the wind blows...
#1
Hi, I am currently using the following:

1. D80
2. Sunpak B3600D, flash

The flash and D80 doesn't 'talk'. The cam doesn't fire the flash. I tried in all the modes on the cam and the flash in auto mode.

I was told that I should masked the pins of the flash (which comes with 4 pins) leaving only the centre pin in contact with the cam.

My question now is not to mask the pins har? Scotch tape?:dunno:

TIA!:)
 

blazer_workz

Senior Member
May 8, 2006
3,118
0
0
ClubSNAP Community
#2
Hi, I am currently using the following:

1. D80
2. Sunpak B3600D, flash

The flash and D80 doesn't 'talk'. The cam doesn't fire the flash. I tried in all the modes on the cam and the flash in auto mode.

I was told that I should masked the pins of the flash (which comes with 4 pins) leaving only the centre pin in contact with the cam.

My question now is not to mask the pins har? Scotch tape?:dunno:

TIA!:)
Electrical insulation tapes
 

Status
Not open for further replies.
Top Bottom