• CROSSING BRIDGES 16 - PHILIPPINES 2019 - 25 April to 2 May 2019. Limited to 20 participant only, Visit this thread for more information.

LR Tips A Quick before and after


Senior Member
Sep 27, 2006
So I thought I would walk you through a quick edit and let you in on my thoughts.
Starting image… reset to just the RAW image for you to see all the steps. (I have a preset that is applied on import usually.)

The first step that sets the tone for the image and helps clarify the editing is getting the crop and composition how I like it. I crop to the image, not to a set ratio, but some folks prefer to keep certain ratios for printing… it is up to you. Since the main story of the image is the boy and his bike, there is a lot of extraneous area that can be cropped. For action shooting, it is often better to shoot a little wider/looser and then crop after the fact, where as in most slower situations trying to get the composition in camera is always a good practice. In this crop I put Sam on the left third to give him room to move into the frame, and I made sure to show a little of the ground to give visual clues about how high he is jumping.
First step… get the composition/crop right.

after the crop

After the crop, I then click Auto tone to make sure the black and white points are set, and then I usually bring back the exposure just a touch as it tends to run a little too bright. I tweak a few settings such as Highlights and Shadows and add a little Clarity. Lately, I have been dialing down the Vibrance and Saturation just a touch also, but that is a personal taste.
Tone settings

after toning adjustments

After working the toning, I look for distractions that I can remove. The rock on the jump, the post and some bright spots and lines in the background. This helps settle the image and not have parts that are pulling the eye away from the main story.
The points of the spot healing tool used for removing distractions

After removing distracting elements, the next step is to tone down any parts of the image that are too sharp or bright. Bright parts and sharp areas call for the eye to investigate, so if I can tone these parts down, the eye will spend more time where I want it to… so the first thing I do is tone down the dirt hill in front that is pretty bright by using the Gradient tool and setting it to darken just a touch and using a -100 Sharpness to give it a bit of a blur, so that the eye will pass more easily from the hill to Sam’s face.
Gradient tool to darken the jump just a touch

Gradient tool settings

Now I use the Adjust brush to tackle the back area and tone down the bright tree trunks and give the whole area a bit of a blur, so that Sam has even a bit more separation.
Overlay showing where the background has been toned down

finished image

After the crop… comparison

So there you go, nothing fancy but, this is the kind of editing that I do on a regular basis with most of my images. Hope that helps
The post A Quick before and after appeared first on Lightroom Killer Tips.


Top Bottom