i am going to install this blinds sort of thing over my gf's door for her..

thing is i dun relli noe much abt keeping the drilling neat and clean cos normally when i drill stuff the hole wld be covered by the fittings..so any advice how to go abt achieving tt

in this case the holes on the wall wld still be visible..

the ornament wld be propped in place by inserting a screw or nail into one of many holes in its frame..

get wat i'm trying to say?

was thinking of just using screws to prop it in place wih wall plugs
but wld it be unsightly?

suggestions pls..