Dead Pixel

just 2 months, i discovered that my 602 got dead pixel, about 2-3 red/blue dot on d output image, when i shoot night scene.
can i send Scv Ctr claim for warranty?
should i do that?
bcoz i worry once the DC being repair, it might caused worse than b4, others problem might following.
hope to get some advice from all experts here b4 action take.
thxxxx!

[Zerstorer]

Quote: Originally posted by takeshi just 2 months, i discovered that my 602 got dead pixel, about 2-3 red/blue dot on d output image, when i shoot night scene. can i send Scv Ctr claim for warranty? should i do that? bcoz i worry once the DC being repair, it might caused worse than b4, others problem might following. hope to get some advice from all experts here b4 action take. thxxxx!

Only for night scene? Then its probably hot pixels and not dead pixels.

I suppose you are shooting in Auto/A/P/S modes? Try switching to Manual mode instead. The 602 has noise reduction only in Manual mode.

all dead pixels i meant all shown on same location le!
btw i always set at M mode for all shooting.
do u experience the printout seem yellowish from kodak outlet?

[Zerstorer]

Quote: Originally posted by takeshi all dead pixels i meant all shown on same location le! btw i always set at M mode for all shooting. do u experience the printout seem yellowish from kodak outlet?

If you're sure then best to send it to the Fuji service centre and see if you are eligible for replacement.